VM Audio SRA2200.1 Spezifikationen

SRA1500.1 / SRA2200.1MONO AMPLIFIERS

17 18CALIBRATIONSetting Gain1. Turn the gain and bass control all the way down (counterclockwise).2. Turn the vehicle on, and make sure the source uni

19 20TROUBLESHOOTINGIf the amplier does not appear to be working, check for blown fuses, poor or incorrect wiring connections and incorrect settings.

21 22SPECIFICATIONSMODELSOUTPUT CHANNELSPOWER per channel4Ω2ΩTHD-N @ 4ΩFREQ. RESPONSELOWPASSSUBSONICBASS BOOSTINPUT SENSITIVITYINPUT IMPEDANCES/N RATI

23 24CONSUMER LIMITED WARRANTY AGREEMENT Your product is covered by a limited warranty by VM Audio as established below: Mobile Electronics Limited Wa

2CONTENTS INTRODUCTIONThank you for your interest in VM Audio products. Our goal is to enhance your listening experience. The Shaker Series was desig

3 4FUNCTIONSFront Panel1. INPUT: Audio Cable Jack Connections2. OUTPUT: Audio Cable Jack Connections3. GAIN: Input Signal Adjustment Knob4. BASS BOOST

Mounting• Mount the amplier on a at, secure surface.• Investigate the layout of your automobile thoroughly before drilling.• Place the amplier in a

7 8INSTALLATION POWER CONNECTIONS123Mark the mounting screw holes to be drilled with a marker.WARNING! Be aware of gas tanks, gas lines, hydraulic lin

9 101. Locate the remote wire on the stereo head unit. 2. Route the remote wire with a wire length that expands from the stereo head unit all the way

11 12AUDIO INPUT LINE OUTPUTThe audio inputs on the side panel of the amplier receive low level signals from the RCA outputs of the stereo head unit.

13 14SPEAKER WIRINGSingle Subwoofer WiringConnect the subwoofer’s positive + terminal to the positive + terminal on the amplier, then connect the neg

15 16Series Subwoofer Wiring80 HzAmplier Filter SettingsConnect subwoofer 1’s positive + terminal to the negative (-) terminal on subwoofer 2, then c